2003 Peugeot Boxer

Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Brake pipe clips or supports missing, pipe adequately supported (1.1.11 (d) (i))

underside blacked

Brake load sensing valve linkage obviously incorrectly adjusted (1.1.17 (b))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pipe clips or supports missing, pipe adequately supported (1.1.11 (d) (i))

welding repairs heavily blacked/sealed

Brake load sensing valve linkage obviously incorrectly adjusted (1.1.17 (b))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Brake pipe clips or supports missing, pipe adequately supported (1.1.11 (d) (i))

welding repairs heavily blacked/sealed

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

battery lead insecure

under side heavily blacked

Exhaust poor condition

Vehicle heavily under sealed

Exhaust has a minor leak of exhaust gases exh poor cond (6.1.2 (a))

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Suspension component mounting repair covered in underseal underside of vehicle (5.3.6 (a) (i))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Suspension component mounting prescribed area is corroded but not considered excessive underside of vehicle (5.3.6 (a) (i))

exh poor cond

Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension component mounting prescribed area is corroded but not considered excessive underside of vehicle (5.3.6 (a) (i))

Nearside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cross member (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension component mounting prescribed area is corroded but not considered excessive underside of vehicle (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Front Shock absorbers light misting of oil or has limited damping effect both (5.3.2 (b))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

exh poor cond

Brake load sensing valve stiff (3.6.E.3)

Exhaust system showing signs of corrosion.

Front registration plate cracked but still readable.

N/s/f wheel bearing slightly noisy.

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Service brake: efficiency below requirements (3.7.B.7)

rear brake binding (3.7.B.1)

Brake load sensing valve stiff (3.6.E.3)

Exhaust system showing signs of corrosion.

Front registration plate cracked but still readable.

N/s/f wheel bearing slightly noisy.

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

Nearside Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings inner sill (6.1.B.2)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings out riggers (6.1.B.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner arch (6.1.B.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outriggers (6.1.B.2)

Offside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings inner arch (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner panel (6.1.B.2)

Service brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

front number plate deteriorated

front tyres are wearing unevenly

nearside rear crossmember corroed

Nearside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Leaf spring deteriorated and seriously weakened (2.4.B.1a)

Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Front Brake pad(s) wearing thin (3.5.1g)

front number plate deteriorated

front tyres are wearing unevenly

nearside rear crossmember corroed

front number plate damaged

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Parking brake: efficiency below requirements (3.7.B.7)

front number plate damaged

Spare tyre defective

Nearside Headlamp aim too high (1.8)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp aim too high (1.8)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt insecurely fixed to the seat (5.2.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Spare tyre defective

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

FRONT DISCS PADS WEARING LOW

O/S WIPER BLADE STARTING TO SPLIT

O/S/R & O/S/F INDICATOR BULBS STARTING TO FADE

PEDAL RUBBER HAS SMALL SPLIT

Front Brake pad(s) wearing thin (3.5.1g)

Oil leak