2005 Fiat Ducato

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Front Brake pipe likely to become detached or damaged inner wing corroded (1.1.11 (d) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength front (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Subframe mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Exhaust mounting defective (6.1.2 (a))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced rear inner sill and wheel arch (6.1.1 (c) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive both chassis (5.3.6 (a) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Inner wheel arch corroded

Offside Rear sill at rear corroded

hand brake cable poor

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Nearside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength both (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive both chassis (5.3.6 (a) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front brake hose insecure

Offside Rear Inner wheel arch corroded

Offside Rear sill at rear corroded

hand brake cable poor

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive out rigger (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both front inner wings and chassis (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive rear valance (5.3.6 (a) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point (5.3.6 (a) (i))

Nearside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength front mount (5.3.6 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength rear mount (5.3.6 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength front mount (5.3.6 (a) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Inner sill corroded not in zone

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear out rigger corroded not in zone

Suspension component mounting prescribed area is corroded but not considered excessive both front inner wings (5.3.6 (a) (i))

rear valance corroded

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Inner sill corroded

Rear valance corroded

bonnet hinge broken

Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength subframe mount (5.3.6 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Headlamp insecure (4.1.1 (c))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Front Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Inner sill corroded

Rear valance corroded

bonnet hinge broken

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear spring mounting[crossmember] (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength subframe mounting (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength subframe mounting, rear (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

all tyres not of commercial rating

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive chassis (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive chassis (2.4.A.3)

Offside Track rod end ball joint dust cover damaged, but preventing the ingress of dirt (2.2.C.1c)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Rear valance corroded

battery loose

Brake fluid warning lamp illuminated (3.6.G.2)

Emissions not tested (7.3.A.1)

Exhaust emits excessive smoke or vapour of any colour (7.4.B.4)

Front Brakes imbalanced across an axle (3.7.B.5b)

Offside Rear Wheel bolt(s) missing (4.2.A.1e)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive chassis (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive chassis (2.4.A.3)

Offside Track rod end ball joint dust cover damaged, but preventing the ingress of dirt (2.2.C.1c)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Rear valance corroded

battery loose

Centre Rear Seat belt damaged but webbing not significantly weakened (5.2.2a)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front brake binding slightly

Nearside Rear Leaf spring has slight wear in a shackle pin and/or bush (2.4.B.2)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive front mount (2.4.A.3)

Offside Rear Seat belt damaged but webbing not significantly weakened (5.2.2a)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive front mount (2.4.A.3)

Tyre worn close to the legal limit all (4.1.E.1)

Brake load sensing valve seized (3.6.E.3)

Brake pedal spongy (3.3.B.1b)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Leaf spring has excessive wear in a shackle pin and/or bush (2.4.B.2)

Offside Rear Leaf spring has excessive wear in an anchor pin and/or bush (2.4.B.2)

Offside Rear Suspension spring mounting prescribed area is excessively corroded rear mount (2.4.A.3)

Centre Rear Seat belt damaged but webbing not significantly weakened (5.2.2a)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front brake binding slightly

Nearside Rear Leaf spring has slight wear in a shackle pin and/or bush (2.4.B.2)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive front mount (2.4.A.3)

Offside Rear Seat belt damaged but webbing not significantly weakened (5.2.2a)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive front mount (2.4.A.3)

Rear Brake lining(s) wearing thin (3.5.1g)

Tyre worn close to the legal limit all (4.1.E.1)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Leaf spring anchor bracket corroded but not seriously weakened (2.4.B.6d)

Rear Leaf spring has slight wear in a shackle pin and/or bush (2.4.B.2)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Rear Leaf spring anchor bracket corroded but not seriously weakened (2.4.B.6d)

Rear Leaf spring has slight wear in a shackle pin and/or bush (2.4.B.2)

Brake load sensing valve seized (3.6.E.3)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp aim too low (1.8)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Headlamp aim too high (1.8)

Offside Headlamp insecure (1.7.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

fan belt badly breaking up

Brake load sensing valve linkage seized (3.6.E.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

fan belt badly breaking up

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nail in offside front tyre

Nail in offside rear tyre

wheel nut on n/s/f not screwed in

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear rear brakes release unevenly (3.7.B.4)