2005 Ford Galaxy

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Coil spring worn (5.3.1 (b) (i))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Coil spring worn (5.3.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Coil spring worn (5.3.1 (b) (i))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Coil spring worn (5.3.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Macpherson strut has slight movement at the upper attachment both side (2.5.A.1c)

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

brake pad warning light on

slight leak of grease from n/s outer driveshaft gaiter

both front drive shaft inner joint boots split and letting out cv grease

exhaust system is insurcure

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

both front drive shaft inner joint boots split and letting out cv grease

exhaust system is insurcure

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

both rear tyrs 2mm on edges