2014 BMW 118

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Anti-roll bar pin or bush worn but not resulting in excessive movement All (5.3.4 (a) (i))

Chassis/subframes corroded

Suspension arm pin or bush worn but not resulting in excessive movement All (5.3.4 (a) (i))

Underbody corroded

Undertrays fitted

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement Front arm inner bush (5.3.4 (a) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Inner Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Rear Seat belt not functioning as intended (7.1.2 (c))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp aim too high (4.1.2 (a))

Front Registration plate insecure (0.1 (a))

Nearside Rear Brake pipe excessively corroded across axle (1.1.11 (c))

Windscreen washer provides insufficient washer liquid (3.5 (a))

EML/MIL (Engine Management Light) - vehicle was presented with warning lamp illuminated whilst engine running, which went out & stayed out post 2nd engine start up - if EML returns further investigation may be required to confirm fault

Vehicle has a manufacturer's safety recall listed on it at the time of test (see attached paperwork)

Central Rear Seat belt retracting mechanism defective (7.1.2 (e))

Central rear seatbelt action stiff

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Central rear seatbelt action stiff

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Central Rear Seat belt locking mechanism does not secure or release (5.2.5a)

Parking brake lever has no reserve travel (3.1.6b)

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

damage to rear bumper

under trays fitted to vehicle

Brake pad(s) less than 1.5 mm thick (3.5.1g)

Central Seat belt locking mechanism does not secure or release (5.2.5a)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Parking brake lever has no reserve travel (3.1.6b)

Registration plate lamp not working (1.1.C.1d)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Rear Brake pad(s) wearing thin (3.5.1g)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components