2005 Hyundai Getz

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both d bushes have slight play (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material inner wheel arch (1.1.11 (c))

Nearside Front Play in steering rack inner joint(s) ()

Offside Rear Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material both as join the hoses (1.1.11 (c))

Rear both rear wheel arches are made from filler but no holes or rot in sight

Front Anti-roll bar linkage ball joint excessively worn both droplinks (5.3.4 (a) (i))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material inner wheel arch (1.1.11 (c))

Nearside Front Play in steering rack inner joint(s) ()

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material both as join the hoses (1.1.11 (c))

Rear both rear wheel arches are made from filler but no holes or rot in sight

Brake disc worn, pitted or scored, but not seriously weakened both fronts (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Brake pipe excessively corroded both front to rear steel brake pipes corroded wear coming from engine bay area to under side (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Exhaust has a major leak of exhaust gases flex blowing (6.1.2 (a))

Offside Front Headlamp aim too high (4.1.2 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Brake disc worn, pitted or scored, but not seriously weakened both fronts (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pipe slightly corroded on abs unit (3.6.B.2c)

Offside Front Inner Tyre worn close to the legal limit edge bald (4.1.E.1)

Offside Rear tyre pressure low

Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brake pipe slightly corroded on abs unit (3.6.B.2c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Inner Tyre worn close to the legal limit edge bald (4.1.E.1)

Offside Rear tyre pressure low

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake pipe slightly corroded (3.6.B.2c)

Brake pad(s) wearing thin front (3.5.1g)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

front exhaust flexi pipe spilt

Nearside Front Sub-frame corroded and seriously weakened (2.4.G.1)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

front exhaust flexi pipe spilt

front exhaust flexi joint insecure

Exhaust has a minor leak of exhaust gases (7.1.2)

front exhaust flexi joint deterioated

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

front brake pads getting low