2006 Ford Focus

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint excessively worn and dust cover split (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage ball joint excessively worn and dust cover split (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush excessively worn main trailing arm bush (5.3.4 (a) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Lower Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake pad(s) wearing thin nearside and offside (1.1.13 (a) (ii))

Front exhaust flexible pipe has a temporary repair

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords outer side wall (5.2.3 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Nearside Rear Suspension arm corroded but not seriously weakened all arms on limit (5.3.3 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Suspension arm corroded but not seriously weakened all arms on limit (5.3.3 (b) (i))

Oil leak, but not excessive engine oil (8.4.1 (a) (i))

Rear Other passenger door catch deteriorated so the door cannot be readily opened or closed boot lid (6.2.3 (c) (i))

Rear Sub-frame corroded but not seriously weakened on limit (5.3.3 (b) (i))

Rear exhaust heat shield insecure but not likely to fall off

Front Exhaust has a minor leak of exhaust gases Flexi joint x 2 (6.1.2 (a))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Rear Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Front Exhaust has a minor leak of exhaust gases Flexi joint x 2 (6.1.2 (a))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Rear Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Outer Suspension component mounting prescribed area is corroded but not considered excessive Both sills (5.3.6 (a) (i))

Nearside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Outer Suspension component mounting prescribed area is corroded but not considered excessive Both sills (5.3.6 (a) (i))

All direction indicators slightly discoloured (4.4.3 (a))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Exhaust system insecure (6.1.2 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

All direction indicators slightly discoloured (4.4.3 (a))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

exhaust heatshield insecure.

offside and nearside front suspension arm bushes deteriorating!

offside and nearside front tyres worn close to limit!

Engine MIL inoperative or indicates a malfunction cat below efficiency? (8.2.1.2 (h))

exhaust heatshield insecure.

offside and nearside front suspension arm bushes deteriorating!

offside and nearside front tyres worn close to limit!

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

offside and nearside front brake discs inner faces corroding and worn.

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Central Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' soft toys (8.3.1e)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

both front tyres worn on inner edges

Nearside Front Direction indicator slightly discoloured (1.4.A.2f)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

offside and nearside front tyres worn inner edges

Front registration plate letter/figure missing (6.3.1c)

Nearside Front Direction indicator slightly discoloured (1.4.A.2f)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

offside and nearside front tyres worn inner edges

offside rear tyre under inflated

offside and nearside front tyres worn inner edges

Offside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Offside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Centre Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)