2007 Ford Fiesta

Nearside Front Tyre worn close to legal limit/worn on edge 3.0 mm (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge 3.0 mm (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge 3.0 mm (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge 3.0 mm (5.2.3 (e))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Tyre has ply or cords damaged (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Exhaust system insecure (6.1.2 (a))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

nearside front tyre outer wall has cuts in it

Driver's view of the road through the swept area of the windscreen significantly affected by an obstruction (3.1 (a) (ii))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 195/55/15 (5.2.3 (e))

Offside Rear Inner Road wheel slightly distorted (5.2.2 (c) (i))

nearside front tyre worn outer edge

Central Undertray insecure (8.1.1 (b) (i))

Offside Rear Inner Road wheel slightly distorted (5.2.2 (c) (i))

nearside front tyre worn outer edge

tested under wet conditions

Offside Front Inner Tyre has a tear, caused by separation or partial failure of its structure sidewall (4.1.D.1b)

tested under wet conditions

see seperate sheet.

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

rear exhaust heat sheild loose

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)