2009 Land Rover Discovery

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill corroded (5.3.6 (a) (i))

Offside Rear Upper Suspension component pin or bush excessively worn upper hub bush dust cover no longer prevents the ingress of dirt (5.3.4 (a) (i))

Nearside Front Brake disc in such a condition that it is seriously weakened corroded and delaminated (1.1.14 (a) (ii)) DANGEROUS

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

surface rusting to underside of vehicle and suspension components

Nearside Cab steps so insecure it is likely to cause injury Full length (6.2.8 (a) (ii))

Offside Cab steps so insecure it is likely to cause injury Full length (6.2.8 (a) (ii))

Offside Rear Upper Suspension arm pin or bush excessively worn Inner (5.3.4 (a) (i))

Driver's view Items removed from driver's view prior to test (3.1 (a) (ii))

Rust scale on body underside and suspension

Tyre worn close to legal limit/worn on edge both front wearing on inner edges (5.2.3 (e))

general corrosion to underside

Suspension arm pin or bush excessively worn both front lower arm rear bushes (5.3.4 (a) (i))

Tyre worn close to legal limit/worn on edge both front wearing on inner edges (5.2.3 (e))

general corrosion to underside

Engine covers fitted obscuring some components in the engine bay

Rear Brake pad(s) wearing thin (3.5.1g)

Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

rear brake pads getting low

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

rear brake pads getting low