2010 Kia Picanto

Brake pipe corroded, covered in grease or other material Various steel (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension component corroded but not seriously weakened axle beam (5.3.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake pipe corroded, covered in grease or other material Various other steel pipes (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge Plus cracked (5.2.3 (e))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Brake pipe corroded, covered in grease or other material Various other steel pipes (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge Plus cracked (5.2.3 (e))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake pipe corroded, covered in grease or other material some steel (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Service brake lagging in operation (1.2.1 (d))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Brake pipe corroded, covered in grease or other material some steel (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust mounting defective (6.1.2 (a))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Advanced corrosion on front and centre exhaust sections

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Tyre worn close to the legal limit both sides, both BORDERLINE (4.1.E.1)

Exhaust system not adequately supported (7.1.1)

Offside Rear coil spring broken (2.4.C.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear coil spring broken (2.4.C.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

eml on

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)