2001 Subaru Forester

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Upper Coil spring mounting corroded and seriously weakened Top strut turret (5.3.1 (b) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Upper Coil spring mounting corroded and seriously weakened Top strut turret (5.3.1 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge edges (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge edges (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

exhaust system badly corroded slightly weeping at center area

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

exhaust rusty and rear box outer kin peeling

front brake discs rusty on surfaces

exhaust rear box outer skin peeling

exhaust system rusty

front brake discs rusty on surfaces

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

exhaust rear box outer skin peeling

exhaust system rusty

front brake discs rusty on surfaces

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

exhaust system rusty and rear box outer skin peeling

front brake discs corroded/rusty on inner/outer surfaces

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

exhaust system rusty and rear box outer skin peeling

front brake discs corroded/rusty on inner/outer surfaces

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear coil spring corroded (2.4.C.1b)

front brake discs corroded on outer surfaces

osf and nsf tyres 3mm inner edges

rear exhaust box outer skin falling off

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Headlamp aim too high (1.8)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear coil spring corroded (2.4.C.1b)

front brake discs corroded on outer surfaces

osf and nsf tyres 3mm inner edges

rear exhaust box outer skin falling off

Exhaust has part of the system slightly deteriorated (7.1.1a)

N/S front brake disc starting to rust across outer braking surface

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

n/s/r tyre getting low on outer edge.

Nearside Brake pad(s) wearing thin (3.5.1g)

Offside Brake pad(s) wearing thin (3.5.1g)