2006 Toyota Aygo

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Headlamp lens slightly defective Both Sides (4.1.1 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake pipe corroded, covered in grease or other material Both Sides (1.1.11 (c))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced Both Sides Outer Sills (6.1.1 (c) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

clutch limited life

Exhaust Lambda reading after 2nd fast idle outside specified limits exhaust blowing (8.2.1.2 (c))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nail in nearside rear tyre

nearside front tyre worn inner edge

offside front tyre worn low inner edge

Centre Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nail in nearside rear tyre

nearside front tyre worn inner edge

offside front tyre worn low inner edge

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

non standard rear exhaust mount fitted

Front Brake pad(s) wearing thin (3.5.1g)

non standard rear exhaust mount fitted

Offside Front Headlamp aim too low (1.8)