2007 Citroen C2

Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Shock absorbers has a slightly worn bush Piston rod bush. (5.3.2 (c))

Nearside Side repeater lens defective which has no effect on emitted light lens missing. (4.4.1 (b) (i))

Offside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Windscreen washer not working (3.5 (a))

Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Shock absorbers has a slightly worn bush Piston rod bush. (5.3.2 (c))

Nearside Side repeater lens defective which has no effect on emitted light lens missing. (4.4.1 (b) (i))

Offside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Rear Direction indicator slightly discoloured both sides. (4.4.3 (a))

Nearside Rear Inner Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer/inner sill and wheel arch end (5.3.6 (a) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area is inadequately repaired non continuous welding and patches not connected to the main panel (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Items removed from driver's view prior to test ()

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear coil spring corroded (2.4.C.1b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Upper Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

battery insecure

exhaust rear mount deteriorated to excess but system still supported

offside rear brake slightly binding

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)