2010 Renault Kangoo

Front Headlamp has a product on the lens but not seriously reducing light output Both (4.1.4 (b))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material Both pipes (1.1.11 (c))

Offside Front Inner Play in steering rack inner joint(s) ()

Offside Rear Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Rear Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Nearside Front Inner Prop shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material Both pipes (1.1.11 (c))

Offside Front Inner Play in steering rack inner joint(s) ()

Offside Rear Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Shock absorbers has light misting of oil Both sides (5.3.2 (b))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Central Rear Brake pipe corroded, covered in grease or other material on rear axle (1.1.11 (c))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Brake master cylinder defective but brake still operating pedal sticking down (1.1.10 (b) (i))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Central Rear Brake pipe corroded, covered in grease or other material on rear axle (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Nearside Front Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear Outer Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)