2012 Volkswagen Crafter

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Central Rear Prop shaft bearing excessively worn Rear-most bearing/carrier (6.1.7 (b) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Rear reflector missing (4.8.2 (a) (ii))

Offside Front Service brake excessively fluctuating (1.2.1 (e))

Oil leaking excessively from engine (8.4.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Exhaust mounting defective Exhaust resting on subframe (6.1.2 (a))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Central Rear Prop shaft bearing has slight play (6.1.7 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Brake pipe slightly corroded Front to Rear (3.6.B.2c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Parking brake: efficiency below requirements (3.7.B.7)