2003 Subaru Impreza

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Nearside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Rear Subframe mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Subframe mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Offside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Sub-frame corroded but not seriously weakened heavily corroded and also all rear suspension arms heavily corroded (5.3.3 (b) (i))

after market bonnet scoop fitted partially restricting drivers view

looks like it has just been dragged out of a field

Brake fluid warning lamp illuminated (1.1.10 (f))

sill covers fitted

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Driver's door cannot be opened from inside the vehicle (6.2.3 (a))

Driver's view of the road through the swept area of the windscreen materially affected by an obstruction (3.1 (a) (ii))

Front Registration plate missing (0.1 (a))

Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Service brake efficiency below requirements (1.2.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake fluid warning lamp illuminated (1.1.10 (f))

sill covers fitted

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Parking brake lever has little reserve travel (3.1.6b)

Sub-frame corroded but not seriously weakened both (2.4.G.1)

covers fitted obscuring some components

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Parking brake lever has little reserve travel (3.1.6b)

Sub-frame corroded but not seriously weakened both (2.4.G.1)

covers fitted obscuring some components

tyres wearing on inner edges

Nearside Rear Seat belt retracting mechanism defective (5.2.5b)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Front Tyres worn on edges

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Rear Body has slight corrosion behind rear wheel, corrosion is excessive but is outside of prescribed area (6.1.B.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Parking brake lever has little reserve travel (3.1.6b)

Parking brake lever has little reserve travel (3.1.6b)

Rear Body has slight corrosion Sills and rear of body, advise removing plastic sill cover to inspect corrosion. (6.1.B.2)

Front tyres edges worn

Nearside Rear Upper Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Upper Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

general surface corrosion to offside and nearside inner sills

general surface corrosion to rear suspension subframe

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front tyres edges worn

Nearside Rear Upper Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Upper Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

general surface corrosion to offside and nearside inner sills

general surface corrosion to rear suspension subframe

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

all brake discs slightly corroded

Nearside Rear Shock absorber has negligible damping effect (2.7.5)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Shock absorber has negligible damping effect (2.7.5)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

all brake discs slightly corroded

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear Shock absorber has negligible damping effect (2.7.5)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Shock absorber has negligible damping effect (2.7.5)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

nearside front brake disc slightly coroded

offside front brake disc slighty corroded

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

front pads wearing thin

rear discs surface corrosion

front pads wearing thin

rear discs surface corrosion