2008 Peugeot 206

Integral body structure is corroded but structural rigidity is not significantly reduced bulk head and nearside inner wing in engine bay (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis and axle mounting (5.3.6 (a) (i))

Offside Rear Suspension arm damaged but not seriously weakened swing arm bearing red rust room out no room in bearing (5.3.3 (b) (i))

Power steering component has slight seepage from a component around steering rack (2.1.5 (a))

Suspension arm pin or bush worn but not resulting in excessive movement both front inner (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both front inner wheel arches (5.3.6 (a) (i))

oil around engine

Offside Rear Brakes imbalanced across an axle and hand brake performance (1.2.1 (b) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced chassis in floor (7.1.1 (a) (i))

Rear Exhaust system insecure (6.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced bulk head and near side inner wing in engine bay (6.1.1 (c) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement axle arm bearing red rust no room in bearing (5.3.4 (a) (i))

Power steering component has slight seepage from a component steering rack damp around (2.1.5 (a))

Suspension arm pin or bush worn but not resulting in excessive movement both front lower arms rear bushes (5.3.4 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement both front lower arms rear bushes (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both front inner wheel arches (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive rear axle mountings and near side rear chassis (5.3.6 (a) (i))

engine oil sump corroded and very weak

Front Hydraulic leak, but not excessive (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt Plus excessive play (5.3.4 (b) (ii))

Nearside Rear Direction indicator adversely affected by the operation of another lamp (4.4.3 (b))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Direction indicator adversely affected by the operation of another lamp (4.4.3 (b))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Front Hydraulic leak, but not excessive (8.4.1 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Tyre worn close to legal limit/worn on edge Both tyres cracking and very close to canvas on inner edge (5.2.3 (e))

power steering pipe slightly leaking where connects to rack

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Fuel tank insecure (6.1.3 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust system insecure (6.1.2 (a))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust noisy (8.1.1 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Emissions not tested exhaust leak (8.2.1.2 (d))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Fog lamp insecure

Nearside Front Suspension top mount slightly corroded.

Nearside Front position lamp(s) not working (1.1.A.3b)

front brake application uneven (3.7.B.2)

Nearside Front Fog lamp insecure

Nearside Front Suspension top mount slightly corroded.

Nearside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear rear brake binding (3.7.B.1)

Rear fog lamp not working (1.3.2b)

Nearside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear silencer cracked/deteriorated