2009 Kia Rio

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Exhaust mounting defective front and center (6.1.2 (a))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge 2.5mm (5.2.3 (e))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 47% (1.2.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Suspension arm pin or bush worn but not resulting in excessive movement front both sides (5.3.4 (a) (i))

windscreen has a small chip

Offside Front Suspension component ball joint excessively worn (5.3.4 (a) (i))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Exhaust mounting defective front and center (6.1.2 (a))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge 2.5mm (5.2.3 (e))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 47% (1.2.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Suspension arm pin or bush worn but not resulting in excessive movement front both sides (5.3.4 (a) (i))

windscreen has a small chip

Nearside Front tyre wearing on inner edges

Offside Rear tyre perishing

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

stone chip in windscreen

Offside Rear tyre starting to perish

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

exhaust flexi outer material deteriorated

power steering pipes slightly corroded at steering rack

Nearside Rear tyre cracking and perishing

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

clutch slave cylinder leaking

high level brake light not working

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)