2005 Honda Jazz

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Emissions not tested due to misfire (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is inadequately repaired floor and inner sill (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Central Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Headlamp lens seriously defective Both front (4.1.1 (b) (ii))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Windscreen wiper blade defective (3.4 (b) (i))

Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake performance not tested System leaking (1.2.1 (g))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill end cap (5.3.6 (a) (i))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill and floor area (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill end cap (5.3.6 (a) (i))

Nearside Rear Brake pipe leaking on a hydraulic braking system on axle by clip (1.1.11 (b) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill area (5.3.6 (a) (i))

Rear beam corroded

Headlamp has a product on the lens but not seriously reducing light output both lamps (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive coil spring area (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive coil spring area (2.4.A.3)

Oil leak ()

Rear axle corroded

Rear wheel arches scabby

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill and inner sill area (2.4.A.3)

Headlamp has a product on the lens but not seriously reducing light output both lamps (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive coil spring area (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive coil spring area (2.4.A.3)

Oil leak ()

Rear axle corroded

Rear wheel arches scabby

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake pipe slightly corroded Advise it be changed (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Only just met Basic Emission's Test

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords Side wall 175.65.14 (4.1.D.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Brake pipe excessively corroded leaking (3.6.B.2c)

Nearside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake pipe slightly corroded Advise it be changed (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Only just met Basic Emission's Test

Front Brake pad(s) wearing thin (3.5.1g)

Nearside rear brake binding (3.7.B.1)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Engine covers fitted obscuring some components in the engine bay

Offside Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

both rear tyres cracked between tread blocks.