2005 Kia Sorento

Brake pedal anti-slip provision missing (1.1.2 (c))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values 6.47m-1 (8.2.2.2 (f))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Sill excessively corroded (7.1.1 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Sill excessively corroded (7.1.1 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Track rod end ball joint worn to the extent there is a serious risk of detachment (2.1.3 (b) (ii)) DANGEROUS

Nearside Rear Suspension arm insecure and impairing directional stability Differential/axle support arm (5.3.3 (a) (ii)) DANGEROUS

Offside Front Track rod end ball joint worn to the extent there is a serious risk of detachment (2.1.3 (b) (ii)) DANGEROUS

All of chassis corroded

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Child Seat fitted not allowing full inspection of adult belt ()

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

brake pipes corroding

front prop shaft removed

inner and outer sills weld repairs and corrosion

play in track rod ends

rear chassis heavily corroding

rear suspension springs possibly stretched

suspension springs corroding

Nearside Rear Suspension arm attachment bracket/mounting corroded but its strength is not seriously reduced (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sills (5.3.6 (a) (i))

Nearside Front Body has a sharp edge caused by damage (6.1.C.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner sill and sill (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Headlamp aim too low (1.8)

Offside Rear Tie bar/rod attachment bracket/mounting corroded and its strength is seriously reduced to axel (2.4.G.1)

Rear fog lamp not working (1.3.2b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Non obligatory mirror damaged ()

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive sills (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear brake disc contaminated by oil (3.5.1h)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Rear fog lamp not working (1.3.2b)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

n/s/r wheel slighty wet of oil

o/s/f wiper blade split

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Parking brake: efficiency below requirements (3.7.C.1b)

Front Brake pad(s) wearing thin (3.5.1g)