2008 Mazda 5

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Subframe mounting prescribed area is corroded but not considered excessive n/s/f & o/s/f sills (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive n/s/r & o/s/r sills (5.3.6 (a) (i))

Brake servo defective or ineffective (1.1.10 (a) (i))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Subframe mounting prescribed area is corroded but not considered excessive n/s/f & o/s/f sills (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive n/s/r & o/s/r sills (5.3.6 (a) (i))

exhaust system corroded center to rear section

under body has general corrosion

Front to rear all four wheel caps fitted

Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement both sides (2.4.G.2)

Rear chassis rail has corrosion

inner sills have corrosion both sides

Nearside Front Outer Front suspension has slight play in an outer ball joint (2.5.B.2a)

coil spring corroded both rear (2.4.C.1b)

front to rear exhuast system corroded

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

slighty mist of oil on osr shocker

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)