2008 Citroen Xsara

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Undertray not fully secure (8.1.1 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Seat belt anchorage prescribed area strength or continuity significantly reduced both outer sills (7.1.1 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

o/s & n/s front tyres worn on outer edge

Offside Service brake excessively fluctuating (1.2.1 (e))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

o/s & n/s front tyres worn on outer edge

Undertray fitted

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Undertray fitted

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

engine covers and undertrays fitted

Fuel system component insecure filter (7.2.1)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Exhaust backbox bracket broken

General underbody corrosion

Offside Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Under-trays fitted obscuring some underside components

Offside Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Under-trays fitted obscuring some underside components