2008 Toyota Aygo

Corrosion to floor and suspension components

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Front Tyre slightly damaged/cracking or perishing both sides (5.2.3 (d) (ii))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Emissions unable to be completed (8.2.1.2 (d))

Corrosion to floor and suspension components

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Front Tyre slightly damaged/cracking or perishing both sides (5.2.3 (d) (ii))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Hand brake efficiency only just met the requirements might need repair or adjustment

Underbody corrosion to floor and suspension components

Corrosion to floor and suspension components

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Offside Front Position lamp not working (4.2.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Registration plate lamp not working (1.1.C.1d)

Advise both front tyres low on tread

Brakes imbalanced across an axle (3.7.B.5b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear brake binding (3.7.B.1)

Offside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)