2010 Mercedes-benz C

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Exhaust has a minor leak of exhaust gases flexi joint, slightly deteriorated by corrosion (6.1.2 (a))

Offside Front Lower Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Front Exhaust has a minor leak of exhaust gases flexi joint, slightly deteriorated by corrosion (6.1.2 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Lower Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Tyre worn close to legal limit/worn on edge offside rear and nearside rear (5.2.3 (e))

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

ENGINE,FLOOR & SILL COVERS FITTED AT TIME OF TEST

N/S/F & O/S/F BRAKE PADS ARE DOWN TO HALF WORN BUT OK AT TIME OF TEST

N/S/R & O/S/R TYRES ARE DOWN TO 2MM ON INNER & OUTER PART OF TYRES.OK AT TIME OF TEST

VERY SLIGHT WEARING ON N/S/F & O/S/F BRAKE DISCS BUT OK AT TIME OF TEST

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Vehicle's internal headlight adjuster altered to recheck lights

Engine covers fitted obscuring some components in the engine bay

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components