2005 Audi A4

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened pads also wearing thin (1.1.14 (a) (ii))

Nearside Front Lower Anti-roll bar linkage damaged but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Inner Subframe mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Inner Subframe mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material offside and nearside (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced around subframe mounting (6.1.1 (c) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material offside and nearside (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced around subframe mounting (6.1.1 (c) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive o/s and n/s (5.3.6 (a) (i))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive o/s and n/s (5.3.6 (a) (i))

Rear Upper Suspension arm corroded but not seriously weakened o/s and n/s (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive o/s and n/s (5.3.6 (a) (i))

Rear Upper Suspension arm corroded but not seriously weakened o/s and n/s (5.3.3 (b) (i))

Front Upper Suspension arm pin or bush excessively worn o/s and n/s ( front of the 2) (5.3.4 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Unable to inspect the rear seat belts due to being fully loaded with lugage

Rear Upper Suspension arm corroded but not seriously weakened o/s and n/s (5.3.3 (b) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Upper Suspension arm pin or bush worn but not resulting in excessive movement both front arms (5.3.4 (a) (i))

Front Tyre worn close to the legal limit both sides (4.1.E.1)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Exhaust system not adequately supported (7.1.1)

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear passenger seat cannot be secured in the upright position. (6.2.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)