2007 Honda Cr-v

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust mount corroded

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Exhaust mount corroded

Front small chip in windscreen

Nearside Rear reflector defective or damaged by up to 50% of the reflecting surface (4.8.1 (a) (i))

Offside Front Outer Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

small chip in front windscreen

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement 'd' bush (5.3.4 (a) (i))

Windscreen damaged but not adversely affecting driver's view small chip (3.2 (a) (i))

Front small chip in front windscreen

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Upper Position lamp not working (4.2.1 (a))

Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear brake pads low but above 1.5 mm.

various ball joint dust covers perished but not leaking.

centre rear exhaust rusty

rear shocks rusty

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nail in offside rear tyre

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)