2003 Peugeot 206

Exhaust has a minor leak of exhaust gases (7.1.2)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

front suspension arm bushes perishing

interior mirror missing

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Upper Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

front suspension arm bushes perishing

front tyres low tread

interior mirror missing

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

bushes pulling out of front suspension arms

Emissions not tested (7.0)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Side repeater missing (1.4.A.2b)

Offside Inner Front constant velocity joint is insecure (2.5.C.1b)

Offside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Stop lamp not working (1.2.1b)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

bushes pulling out of front suspension arms

Nearside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

childs seat fitted to rear

nearside front arm bushes pulling through

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Inner Front constant velocity joint is insecure (2.5.C.1b)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

childs seat fitted to rear

nearside front arm bushes pulling through

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

air bag light on

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Stop lamp not working (1.2.1b)

air bag light on

Brake load sensing valve linkage seized (3.6.E.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Side repeater incorrect colour (1.4.A.2f)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Headlamp aim too low (1.8)

Suspension arm has slight play in a pin/bush (2.4.G.2)

Suspension arm has slight play in a pin/bush (2.4.G.2)