2005 Toyota Aygo

Nearside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength CHASSIS LEG (5.3.6 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength OUTER AND UNDER SILL PANELS (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength OUTER AND UNDER SILL PANELS (5.3.6 (a) (i))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Brake pipe excessively corroded TO REAR (1.1.11 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Nearside Front Headlamp aim projected beam image is obviously incorrect LENS DISFIGURED (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect LENS DISFIGURED (4.1.2 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

CLUTCH BITE HIGH

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength AXLE MOUNTING (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

CLUTCH BITE HIGH

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

clutch bite high

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill panel (5.3.6 (a) (i))

clutch bite high

Nearside Rear Suspension spring mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Slight corrosion inside faces of front discs.

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Horn not a continuous or uniform sound (1.6.2e)

Front brake disc slightly scored (3.5.1h)