2007 Volkswagen Polo

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive sill getting weak (7.1.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced faded (4.1.4 (b))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced x2 (7.1.1 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive sill getting weak (7.1.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn nearside and offside (5.1.2 (b) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill holed (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced holed (7.1.1 (a) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn nearside and offside (5.1.2 (b) (i))

Valve stem slightly damaged all four perishing (5.2.3 (j))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear exhaust heat shield insucure

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Obligatory mirror does not provide a view to the rear glass missing (3.3 (c))

Rear exhaust heat shield insucure

Rear exhaust heat shield loose

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Headlamp aim too high and too far to the right. (1.8)

Nearside Headlamp aim too high (1.8)

Both rear bump stops deteriorated

Offside rear tyre slightly perished

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front Upper Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Stop lamp not working (1.2.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Both rear bump stops deteriorated

Offside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Offside rear tyre slightly perished

Reverse lamps not working

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Both rear tyres perished

Offside rear bump stop deteriorated

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Both rear tyres perished

Exhaust front flexi joint deteriorated

Offside rear bump stop deteriorated

Rear exhaust heat shield insucure

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Centre exhaust silencer outer skin corroding

Offside rear bump stop deteriorated

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Both front tyres slightly cut on outer sidewalls

Exhaust centre silencer slightly corroded

Exhaust front flexi joint slightly deteriorated

Nearside Front Upper Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)