2008 Toyota Aygo

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch hole (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill hole (5.3.6 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner and outer sill holes *duplicate* (7.1.1 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (huge hole (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (huge hole (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner and outer sill holes *duplicate* (7.1.1 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sill (huge hole by frontmost subframe mount (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Tyre obviously under inflated (5.2.3 (l))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Lower Exhaust system insecure (6.1.2 (a))

Nearside Front Outer Tyre has a cut in excess of the requirements deep enough to reach the ply or cords sidewall (5.2.3 (d) (i))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced lower sill (duplicate (7.1.1 (a) (i))

Nearside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength central lower sill (5.3.6 (a) (i))

Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (duplicate (7.1.1 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (3 holes (5.3.6 (a) (i))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (duplicate (7.1.1 (a) (i))

Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (rotten (5.3.6 (a) (i))

Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced lower sill (duplicate (7.1.1 (a) (i))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength lower sill (rotten (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Exhaust emissions likely to be affected by an exhaust leak hole on hanger mount (8.2.1.1 (b))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Central Front Exhaust mounting defective (6.1.2 (a))

Nearside Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Bumper insecure (6.1.4 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Nearside & Offside sills (6.1.1 (c) (i))

Central Front Exhaust mounting defective (6.1.2 (a))

Nearside Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside number plate light dim

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim too low (4.1.2 (a))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside number plate light dim

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

front brake discs in poor condition

front tyres worn on shoulders

o/s/f wheel binding slightly

rear tyres 3mm[limit 1.6mm]

Front discs inner surface rusty/pitted replace on next pad change

NSR tyre on 2-4mm

OSR tyre on 3-4mm

Inner Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

front brake discs corroded inner face