2008 Ford Ka

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength near axle mount (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor at sub frame mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis inner arch near strut mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength near axle mount (5.3.6 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Emissions not tested (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases flexy pipe broken off (6.1.2 (a))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength floor + sill to floor (5.3.6 (a) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear fog lamp switch missing (4.5.3 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected shock absorber mount (5.3.6 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Front Exhaust has a minor leak of exhaust gases flexy pipe (6.1.2 (a))

Nearside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i))

Offside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Front Exhaust has a minor leak of exhaust gases flexy pipe (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Heatshield loose

Oil leak, but not excessive (8.4.1 (a) (i))

Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Horn not working (7.7 (a) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Heatshield loose

Oil leak, but not excessive (8.4.1 (a) (i))

Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Horn not working (1.6.2a)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded Arch (5.2.6)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front coil spring broken (2.4.C.1a)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

front tyres near limit

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

front tyres near limit