2002 Rover 45

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill / floor (5.3.6 (a) (i))

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Inner Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension arm pin or bush excessively worn Trailing arm (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Inner Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush excessively worn Trailing arm (5.3.4 (a) (i))

Exhaust heat shield loose

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Service brake excessively binding both sides (1.2.1 (f))

Front Windscreen washer not working (3.5 (a))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Rear Exhaust silencer insecure (8.1.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Brake hose damaged and likely to fail (1.1.12 (a)) DANGEROUS

Nearside Front Inner Suspension component mounting prescribed area so inadequately repaired that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Offside Front Brake hose damaged and likely to fail (1.1.12 (a)) DANGEROUS

Offside Front Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Subframe mounting prescribed area is excessively corroded rear mount (2.4.A.3)

Offside Front Subframe mounting prescribed area is excessively corroded rear mount (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear disc corroded and pitted

Suspension component mounting prescribed area is corroded but not considered excessive both sides front (2.4.A.3)

rearmost exhaust mounting rubber broken

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Suspension component mounting prescribed area is corroded but not considered excessive both sides front (2.4.A.3)

rearmost exhaust mounting rubber broken

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Headlamp aim too low (1.8)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Headlamp aim too low (1.8)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Front Exhaust system not adequately supported (7.1.1)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

NEARSIDE AND OFFSIDE FRONT FLOORS CORRODED***

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Stop lamp not working (1.2.1b)

Offside rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

front brake application uneven (3.7.B.2)

front brakes release unevenly (3.7.B.4)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)