2002 Peugeot 206

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Nearside Front Upper Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Upper Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake load sensing valve linkage stiff (3.6.E.3)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake load sensing valve linkage stiff (3.6.E.3)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake load sensing valve linkage stiff (3.6.E.3)

Brake pipe slightly corroded (3.6.B.2c)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Stone chip below zone A.