2002 Land Rover Freelander

Rear fog lamp not working (4.5.1 (a) (ii))

Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Road wheel fixing missing all four wheels (5.2.1 (a) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside front to rear brake pipe corroded

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Subframe mounting prescribed area is corroded but not considered excessive front and rear subframe (5.3.6 (a) (i))

Suspension arm corroded but not seriously weakened both nearside and offside front (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear inner and outer sills (5.3.6 (a) (i))

both front brake pipes corroded

both rear diff rubber mounts deteriorated

chassis corroded

some brake pipes are greased, unable to check fully

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside front to rear brake pipe corroded

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Subframe mounting prescribed area is corroded but not considered excessive front and rear subframe (5.3.6 (a) (i))

Suspension arm corroded but not seriously weakened both nearside and offside front (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear inner and outer sills (5.3.6 (a) (i))

both front brake pipes corroded

both rear diff rubber mounts deteriorated

chassis corroded

some brake pipes are greased, unable to check fully

Brake pipe excessively corroded Both front part of main brake pipes front too rear (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Stop lamp(s) all not working (4.3.1 (a) (iii))

SLIGHT CORROSION THROUGHOUT UNDERSIDE OF VEHICLE

VARIOUS AREAS OF CORROSION THROUGHOUT UNDERSIDE OF VEHICLE

Front Brake hose has slight corrosion to ferrules BOTH (3.6.B.4e)

REAR DIFF O/S OUTPUT SHAFT SEAL STARTING TO LEAK OIL

REAR END DOOR CORRODED AROUND CATCH AREA

RUBBER BONDING PERISHED ON PROPSHAFT CARRIER BEARINGS

VARIOUS PATCHES OF CORROSION THROUGHOUT UNDERSIDE OF VEHICLE

Front Brake hose has slight corrosion to ferrules BOTH (3.6.B.4e)

Nearside Stop lamp not working (1.2.1b)

REAR DIFF O/S OUTPUT SHAFT SEAL STARTING TO LEAK OIL

REAR END DOOR CORRODED AROUND CATCH AREA

RUBBER BONDING PERISHED ON PROPSHAFT CARRIER BEARINGS

VARIOUS PATCHES OF CORROSION THROUGHOUT UNDERSIDE OF VEHICLE

centre propshaft carriers, rubber mountings delaminating from metal brackets.

Offside Headlamp aim too low (1.8)

Child seat fitted not allowing full inspection of adult belt

SURFACE RUST ON MOST METAL BRAKE PIPES

TOW HITCH SOCKET FIXINGS INSECRE

Under-trays fitted obscuring some underside components

Offside Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Seat belt locking mechanism does not secure or release (5.2.5a) DANGEROUS

Offside Front Seat belt locking mechanism does not secure or release (5.2.5a) DANGEROUS

Offside Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)