2003 Toyota Yaris

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Front Headlamp aim too low (4.1.2 (a))

Front Headlamp light intensity severely reduced (4.1.4 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear Brake lever has insufficient reserve travel (1.1.2 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

oil leak

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

beam images poor

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Both front anti-roll bar link rod mounting bushes worn and perished

Both front to rear metal brake pipe rusted and degrading

Both front tyres worn to 3mm on the tread shoulders

Both headlamp lenses degrading

Both rear axle to floor pan mounting bushes perished and splitting from the outer casings

Front windscreen washer jets require a clean and adjusting

Front windscreen wiper blades worn

Nearside front tyre perished

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside rear brake binding (3.7.B.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

rear brake application uneven (3.7.B.2)

Both front anti-roll bar link rod mounting bushes worn and perished

Both front to rear metal brake pipe rusted and degrading

Both front tyres worn to 3mm on the tread shoulders

Both headlamp lenses degrading

Both rear axle to floor pan mounting bushes perished and splitting from the outer casings

Front windscreen washer jets require a clean and adjusting

Front windscreen wiper blades worn

Nearside front tyre perished

front registration plate slightly deteriorated

Brakes imbalanced across an axle (3.7.B.5b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Registration plate lamp not working (1.1.5c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

front brake discs worn very thin and scord

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)