2004 Seat Alhambra

Front Brake pipe corroded, covered in grease or other material next to calipper (1.1.11 (c))

Offside Rear wheel arch corrosion

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength INNER SILL (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength INNER SILL (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength INNER SILL (5.3.6 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Steering rack gaiter missing or no longer prevents the ingress of dirt BOTH FROINT (2.1.3 (g) (ii))

Brake pipe corroded, covered in grease or other material SOME STEEL GREASED AND CORRODED (1.1.11 (c))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Seat belt slightly damaged BOTH FRONT (7.1.2 (b) (i))

Suspension arm ball joint dust cover severely deteriorated BOTH FRONT LOWER (5.3.4 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material some steel (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Fuel cap/sealing device component leaking (6.1.3 (b) (i))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Brake pipe corroded, covered in grease or other material some steel (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Shock absorbers light misting of oil or has limited damping effect both rear (5.3.2 (b))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge meets min legal requirement only on outer edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Shock absorbers light misting of oil or has limited damping effect both (5.3.2 (b))

Nearside Rear Tyre wearing on outer edge

Offside Rear Seat belt damaged but webbing not significantly weakened (5.2.2a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front front brake fluctuating, but not excessively (3.7.B.3)

Nearside Rear Tyre wearing on outer edge

Offside Rear Seat belt damaged but webbing not significantly weakened (5.2.2a)

Front Tyres both worn on inner edge

Nearside Front Upper Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Upper Exhaust system not adequately supported rubber mount (7.1.1)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Stop lamp not working (1.2.1b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake lever defective so that it cannot be satisfactorily operated (3.1.3c)