2004 Citroen Berlingo

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Offside Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Offside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Emissions not tested NO EOBD SIGNAL (8.2.2.2 (e))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Horn not working (7.7 (a) (ii))

Nearside Front Side repeater not working (4.4.1 (a) (ii))

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

CLUTCH SLIPPING

Front Windscreen wiper does not clear the windscreen effectively torn (3.4 (b) (ii))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Offside Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Obligatory mirror seriously obscured affecting the rear view (8.1.2a)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear Brake load sensing valve inoperative return spring broken (3.6.E.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Rear Brake load sensing valve inoperative spring missing (3.6.E.3)

engine water leak

Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Nearside Front Lower Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Front Track rod end ball pin shank loose (2.2.B.1c)

Offside Drive shaft which forms part of the suspension coupling gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.4.G.4e)

Offside Front Lower Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Front Track rod end ball pin shank loose (2.2.B.1c)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Brake load sensing valve defective and function impaired (3.6.E.3)

Battery insecure (1.9.1)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Upper Macpherson strut has excessive play in the sliding bush or gland (2.5.B.1b)

Nearside Front coil spring broken (2.4.C.1a)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Stop lamp not working (1.2.1b)

Battery insecure (1.9.1)

Brake load sensing valve linkage seized (3.6.E.3)

Brake pedal has insufficient reserve movement (3.3.A.5)

Brakes imbalanced across an axle (3.7.B.5b)

Driver's airbag obviously defective (5.4.1)

Horn not working (1.6.2a)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)