2008 Suzuki Swift

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Exhaust system insecure (6.1.2 (a))

Front Oil leaking excessively from engine (8.4.1 (a) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Brake pipe excessively corroded x2 (1.1.11 (c))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Brake pipe excessively corroded x2 (1.1.11 (c))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Macpherson strut ball joint has slight play (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Macpherson strut ball joint has slight play (5.3.4 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear brake pipe corroded

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Electronic stability system warning lamp indicates a fault (3.4.1c)

Offside Front Shock absorber has an excessively worn shock absorber pivot (2.7.4)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Brake pipe slightly corroded front to rear (3.6.B.2c)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside rear brake binding (3.7.B.1)

Offside rear brake binding (3.7.B.1)

rear brake application uneven (3.7.B.2)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (back) (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (back) (2.4.G.2)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

ns rear brake slight binding

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)