2002 Peugeot 206

Brake load sensing valve seized (3.6.E.3)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Outer Subframe mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Outer Subframe mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak ()

all other steel brake pipes starting to corrode

brake loads valve sensor rubber gaitor split and allowing dirt in

coil springs corroded

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Brake pipe excessively corroded front to rear (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

exhaust is corroded

slight blow from exhaust joints

slight oil leak

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake load sensing valve linkage seized (3.6.E.3)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Rear Brake load sensing valve linkage seized (3.6.E.3)