2006 Mercedes-benz Vito

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Steering rack has excessive free play detected at the steering wheel (steering rack fitted) rack end (2.3 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength and front inner sill (5.3.6 (a) (i))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

parking brake only just meets requirements

Front Tyre worn close to legal limit/worn on edge x2 (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Horn not working (7.7 (a) (ii))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Front Anti-roll bar linkage ball joint has slight play x2 (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))

Exhaust particulate filter missing where one was fitted as standard (8.2.2.1 (a))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Rear Tyre worn close to the legal limit x2 (4.1.E.1)

engine management fault

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Parking brake lever has no reserve travel (3.1.6b)

Rear Tyre worn close to the legal limit x2 (4.1.E.1)

brake pad warning lamp

engine management fault

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Rear reflector slightly damaged but function not impaired (1.5.1c)

Offside Rear fog lamp not working (1.3.2b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Rear reflector slightly damaged but function not impaired (1.5.1c)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

support bracket for exhaust front pipe broken

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)