2008 Ford Ka

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch area near to strut top mount (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill beside axle mount (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill beside axle mount (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill near to axle mount (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor area next to seat mount (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement axle mount (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement axle mount (5.3.4 (a) (i))

Rear Exhaust has a minor leak of exhaust gases at joint (6.1.2 (a))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Windscreen washer not working (3.5 (a))

Nearside Rear Position lamp not working (4.2.1 (a))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front coil spring broken (2.4.C.1a) DANGEROUS

2 front tyres perrished

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

Both front tyres just under 3mm tread depth left.

Front wiper blades smearing