2008 Toyota Aygo

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Exhaust has a major leak of exhaust gases center section (6.1.2 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to sill holed (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end holed (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength flooor to sill holed (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength lower under sill holed (5.3.6 (a) (i))

Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Front \subframe very rusty

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Front subframe rusty

nearside and offside lower under sill sections rusty and floor to sill rusty

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Service brake excessively binding (1.2.1 (f))

Front subframe rusty

nearside and offside lower under sill sections rusty and floor to sill rusty

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Outer Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Exhaust system insecure brackets missing from rear and mounting broken (6.1.2 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement perished (5.3.4 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear, perished (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement perished (5.3.4 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear, perished (5.3.4 (a) (i))

Items removed from driver's view prior to test ()

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Front Tyre worn close to the legal limit x2 (4.1.E.1)

Nearside Front Inner Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Front Inner Road wheel with a slightly distorted bead rim (4.2.A.1a)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Valve stem seriously misaligned (4.1.D.1e)

Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Suspension arm has slight play in a track control arm inner bush (2.5.B.2b)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Suspension arm has slight play in a track control arm inner bush (2.5.B.2b)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front brakes worn