2012 Volkswagen Cc

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

covers fitted slight oil leak

Front Anti-roll bar linkage ball joint excessively worn both (5.3.4 (a) (i))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Rear Brake disc in such a condition that it is seriously weakened both (1.1.14 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick both (1.1.13 (a) (ii)) DANGEROUS

covers fitted slight oil leak

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Brake disc worn, but not excessively both (1.1.14 (a) (i))

Rear Brake pad(s) wearing thin both (1.1.13 (a) (ii))

Front Tyre tread depth below requirements of 1.6mm both (5.2.3 (e)) DANGEROUS

Rear Tyre tread depth below requirements of 1.6mm both (5.2.3 (e)) DANGEROUS

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Brake disc worn, but not excessively both (1.1.14 (a) (i))

Rear Brake pad(s) wearing thin both (1.1.13 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake disc worn, but not excessively both front, inner sides (1.1.14 (a) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

engine/under tray covers fitted obscuring view

Items removed from driver's view prior to test

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)

Items removed from driver's view prior to test

Front registration plate delaminated but not likely to be misread (6.3.1d)

Rear registration plate delaminated but not likely to be misread (6.3.1d)