2002 Honda CBR900RR

Front Tyre worn close to the legal limit (5.2.3 (e))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front Cannot see fluid in brake reservoir, will check after test

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement Suspension linkage (5.3.4 (a) (i))

Registration plate does not conform to the specified requirements (0.1 (d))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front Cannot see fluid in brake reservoir, will check after test

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement Suspension linkage (5.3.4 (a) (i))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement Suspension linkage (5.3.4 (a) (i))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement Suspension linkage (5.3.4 (a) (i))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Brake pad(s) contaminated (1.1.13 (b))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Brake disc(s) friction surface contaminated by oil or grease (3.2.A1k)

Front Brake pad(s) contaminated by oil or grease (3.2.A1k)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Brake disc(s) has excessive run out (3.2.A1m)

Rear Drive chain excessively loose (6.2.1d)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

noise from front brakes need to be stripped and checked