2003 Land Rover Freelander

rear exhaust silencer corroded

Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Registration plate lamp likely to become detached (4.7.1 (c) (ii))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill assy (6.1.1 (c) (i))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

rear exhaust silencer corroded

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill assy (6.1.1 (c) (i))

Nearside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill assy (6.1.1 (c) (i))

Offside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill assy (6.1.1 (c) (i))

Offside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill assy (6.1.1 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake pipe corroded, covered in grease or other material Both sides (1.1.11 (c))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear Brake pipe corroded, covered in grease or other material Both sides (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust has a minor leak of exhaust gases rear silencer corroded and small blow (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view chip to zone B (3.2 (a) (i))

All direction indicators incorrect colour all lamps faded (4.4.3 (a))

Nearside Rear Seat belt damaged (7.1.2 (b) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Exhaust has a minor leak of exhaust gases rear silencer corroded and small blow (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view chip to zone B (3.2 (a) (i))

Exhaust has a minor leak of exhaust gases rear silencer (6.1.2 (a))

Nearside Front Suspension arm ball joint dust cover severely deteriorated slightly (5.3.4 (b) (i))

Nearside Rear Seat belt slightly damaged (7.1.2 (b) (i))

Windscreen damaged but not adversely affecting driver's view chip to zone B (3.2 (a) (i))

Brake pipe slightly corroded all pipes starting to corrode (3.6.B.2c)

Direction indicator slightly discoloured both front and near side rear (1.4.A.2f)

Exhaust has a minor leak of exhaust gases rear silencer (7.1.2)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Side repeater slightly discoloured (1.4.A.2f)

rear axle mounting deteriorating

rear silencer hanger broken

Brake pipe slightly corroded all pipes starting to corrode (3.6.B.2c)

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

underbody generally rusty due to environment

Advise under trays fitted to vehicle

Rear Exhaust has a minor leak of exhaust gases Silencer (7.1.2)

Brake pipe slightly corroded (3.6.B.2c)

Engine covers fitted obscuring some components in the engine bay

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Under-trays fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen wiper does not clear the windscreen effectively (8.2.2)