2004 Fiat Panda

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Side repeater slightly discoloured Both front wing side repeaters (4.4.3 (a))

Nearside Lower Vehicle structure is corroded but structural rigidity is not significantly reduced Lower outer sill area (6.1.1 (c) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Lower Vehicle structure is corroded but structural rigidity is not significantly reduced Lower outer sill area (6.1.1 (c) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Front Brake hose slightly deteriorated Advise both front flexi hoses outer sleeves split (1.1.12 (b) (ii))

Front Tyre slightly damaged/cracking or perishing Advise both front tyres perishing (5.2.3 (d) (ii))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil leak, but not excessive Engine bay area (8.4.1 (a) (i))

Front Brake hose slightly deteriorated Both fronts (1.1.12 (b) (ii))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer sill holed (6.1.1 (c) (i))

Offside Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer sill holed (6.1.1 (c) (i))

Offside Rear Inner Road wheel badly distorted Inner bead rim damaged (5.2.2 (c) (i))

Front Brake hose slightly deteriorated Both fronts (1.1.12 (b) (ii))

Oil leak, but not excessive Engine bay area advise NEAR FAIL (8.4.1 (a) (i))

Nearside Rear Inner Road wheel slightly distorted Bead rim (5.2.2 (c) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive Engine bay (8.4.1 (a) (i))

Brake lever has insufficient reserve travel Excessive hand brake travel (1.1.2 (a))

Nearside Front Upper Shock absorbers has an excessively worn bush (5.3.2 (c))

Nearside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill area near jacking point (6.1.1 (c) (i))

Nearside Rear Inner Road wheel slightly distorted Bead rim (5.2.2 (c) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil leak, but not excessive Engine bay (8.4.1 (a) (i))

under-trays fitted obscuring some components

Nearside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

(1) Both front to rear metal brake pipes corroded close to limit.

(1) Both front wiper blades deteriorated close to limit.

(1) Centre exhaust mounting braket corroded close to limit.

(3) Engine leaking oil slightly.

(3) Nearside parking brake performance low.

(4) Exhaust blowing slightly from rear box joint.

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Engine oil sump corroded and leaking slightly

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Engine oil sump corroded and leaking slightly

Both front tyres worn on inner edges.

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Exhaust system not adequately supported (7.1.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Both front tyres wearing close to legal limit on inner edge.

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

O/S rear tyre worn close to legal limit.

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

(5) Slight freeplay in nearside front top suspension mounting.

(1) Engine overheating, Rad fan not working.

(2) Nearside front anti roll bar link arm joint worn close to limit.

(3) Rear exhaust deteriorated close to limit.

(6) Nearside rear tyre worn close to limit.

(5) Offside rear tyre worn down to legal limit.

(6) Front brake pads worn close to limit.

(6) Rear exhaust corroded slightly.

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

(5) Offside rear tyre worn down to legal limit.

(6) Front brake pads worn close to limit.

(6) Rear exhaust corroded slightly.

(6) Offside front bottom joint worn slightly.

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)