2008 Toyota Aygo

Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Seat belt not functioning as intended (7.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

front number plate cracked

front roll bar link bushes deteriorated

near side front wheel bolt not correct

off side front seatbelt slightly frayed on edge

rear axle and mountings coated in underseal unable to fully inspect

tape used to secure front bumper

Engine MIL inoperative or indicates a malfunction management light on dash (8.2.1.2 (h))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Front Brake pad(s) worn down to wear indicator (1.1.13 (a) (i))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Service brake excessively fluctuating (1.2.1 (e))

Nearside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Seat belt not functioning as intended (7.1.2 (c))

Nearside Rear Service brake excessively fluctuating (1.2.1 (e))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Bumper insecure (6.1.4 (a) (i))

Offside Rear Seat belt not functioning as intended (7.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front front bumper misaligned but secure

Nearside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake inoperative on one side both low (1.4.1 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Central Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp aim too high (4.1.2 (a))

front wiper deteriating

surface corrosion to rear axle

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

front wiper deteriating

surface corrosion to rear axle

front bumper damaged

Offside Front Headlamp aim too high (1.8)

Offside Front Headlamp insecure (1.7.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Headlamp aim beam image obviously incorrect Both (1.8.A.1b)

Nearside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp insecure (1.7.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)