2012 Mercedes-benz Sprinter

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Fuel system component leaking Injector seal (6.1.3 (b) (i))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer not working (3.5 (a))

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s) ()

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Oil leaking excessively from engine (8.4.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened both front (1.1.14 (a) (ii))

Brake disc worn, pitted or scored, but not seriously weakened both rear (1.1.14 (a) (ii))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement DBush central (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to the legal limit Worn on inner edge (4.1.E.1)

Offside Front Tyre worn close to the legal limit Worn on inner edge (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Emissions too low to register results

Nearside Rear Tyre worn close to the legal limit some perishing to sidewalls (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)