2007 Ford S-max

Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Seat belt installation has cut and/or reworked original webbing (10.1 (a))

Nearside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Offside Rear Stop lamp not working (1.2.1b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Lower Suspension arm synthetic bush deteriorated but not resulting in excessive movement both nearside & offside backend mount (2.4.G.2)

engine oil level low

Front Lower Suspension arm synthetic bush deteriorated but not resulting in excessive movement both nearside & offside backend mount (2.4.G.2)

Front Windscreen wiper does not clear the windscreen effectively both sides / pair (8.2.2)

Rear Inner Brake pad(s) less than 1.5 mm thick both sides / pair / set (3.5.1g)

engine oil level low

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Registration plate lamp not working (1.1.C.1d)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Front registration plate delaminated but not likely to be misread (6.3.1d)

Nearside Headlamp damaged but light output not reduced (1.7.5a)

Front registration plate delaminated but not likely to be misread (6.3.1d)

Rear Parking brake lever has little reserve travel (3.1.6b)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)