1974 Volkswagen Beetle

Front Inner Suspension arm pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Front Steering component mounting prescribed area is excessively corroded floor (steering column) (2.1.2 (e) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Headlamp aim too high (4.1.2 (a))

Position lamp switch does not illuminate the front and rear position lamps with a single operation with ignition off (4.2.2 (a))

Rear Passenger's seat backrest cannot be secured in the upright position. (6.2.6 (a) (i))

Steering system fouling steering arms fouling nearside and offside front lower suspension arms (2.1.4 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Suspension component mounting prescribed area is corroded but not considered excessive both rear inner wings (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive under side (2.4.A.3)

Battery insecure (1.9.1)

Driver's door cannot be opened from inside the vehicle (6.2.B.1b)

Driver's seat cannot be secured in the upright position. (6.2.A.2)

Front All position lamps not working (1.1.A.3b)

Front Body has a sharp edge caused by corrosion (6.1.C.1)

Horn not working (1.6.2a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Rear Lower Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside front brake binding (3.7.B.1)

Nearside rear brake binding (3.7.B.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Lower Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside front brake binding (3.7.B.1)

Offside rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Stop lamp not working (1.2.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

clutch mechanism dangerous as it does not return to upright position