2010 Skoda Fabia

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear exhaust silencer has light corrosion

Shock absorbers has a slightly worn bush Both rear upper bump stop rubbers split/perished (5.3.2 (c))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Rear reflector defective or damaged by up to 50% of the reflecting surface (4.8.1 (a) (i))

Rear Exhaust silencer deteriorated

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases Flexible section (6.1.2 (a))

Nearside Front Road wheel badly distorted (5.2.2 (c) (i))

Nearside Rear Rear reflector defective or damaged by up to 50% of the reflecting surface (4.8.1 (a) (i))

Offside Front Nail in tyre

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Exhaust silencer deteriorated

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Road wheel bead rim badly distorted (4.2.A.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)